Xycom 9465 PC/AT, Manual, Page: 3 / 87

Xycom Revision Record
Revision Description Date
A Manual Released 5/97
B Manual Updated 9/97
C Manual Updated 1/98
D Manual Updated 8/98
E Pentium II updates 11/98
Trademark Information
Brand or product names are registered trademarks of their respective owners.
Windows is a registered trademark of Microsoft Corp. in the United States and other countries.
Copyright Information
This document is copyrighted by Xycom Incorporated (Xycom) and shall not be reproduced or copied without expressed written
authorization from Xycom.
The information contained within this document is subject to change without notice. Xycom does not guarantee the accuracy of the
information and makes no commitment toward keeping it up to date.
United States FCC Part 15, Subpart B, Class A EMI Compliance Statement:
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation
of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
For European Users:
WARNING
This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be
required to take adequate measures.
INSTALLATION: Electromagnetic Compatibility WARNING
The connection of non-shielded equipment interface cables to this equipment will invalidate FCC EMI and European Union EMC
compliance and may result in electromagnetic interference and/or susceptibility levels which are in violation of regulations which
apply to the legal operation of this device. It is the responsibility of the system integrator and/or user to apply the following
directions which relate to installation and configuration:
1. All interface cables must include shielded cables. Braid/foil type shields are recommended. Communication cable connectors
must be metal, ideally zinc die-cast backshell types, and provide 360 degree protection about the interface wires. The cable
shield braid must be terminated directly to the metal connector shell, ground drain wires alone are not adequate.
2. For systems other than Pentium II logic board (AHIP6+): In those cases where an external mouse is used, the snap-on ferrite
bead provided (P/N 116046) must be installed on the mouse cable at the host end in order to comply with relevant EMI
regulations.
3. Protective measures for power and interface cables as described within this manual must be applied. Do not leave cables
connected to unused interfaces or disconnected at one end. Changes or modifications to this device not expressly approved
by the manufacturer could void the user’s authority to operate the equipment.
4. EMC compliance is, in part, a function of PCB design. Third party add-on AT/XT peripheral PCB assemblies installed within
this apparatus may void EMC compliance. FCC/CE compliant PCB assemblies should always be used where possible.
XYCOM can accept no responsibility for the EMC performance of this apparatus after system integrator/user installation of
PCB assemblies not manufactured and/or expressly tested and approved for compliance by XYCOM. It is the responsibility of
the system integrator/user to ensure that installation and operation of such devices does not void EMC compliance.
xycom
Technical Publications Department
750 North Maple Road
Saline, MI 48176–1292
734-429-4971 (phone)
734-429-1010 (fax)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com