XVision X100 Series, User Manual

Page: 25 / 176

X100 Series Main User Manual 25
IN
ST
A
LL
&
C
O
N
N
EC
T
SE
TU
P
CO
N
FIG
U
RE
RE
CO
RD
IN
G
S
O
FT
W
A
RE
Alarm and RS485 Connections
Grouping Cable Name (Colour) Connect to:
ALARM SENSOR
(Optional)
DI (Green/White)
Alarm Sensor Input
DO (Orange/White)
Alarm Output
12V DC (Brown/White)
Alarm Output Power (12V DC 50mA Max)
GND (Blue/White)
Alarm Sensor Ground
RS485
RS485 + (Purple/White)
Not used
RS485 - (Grey)
Not used
Resetting your camera
The Reset Button is used to restore the factory default settings. If you are experiencing problems
with the IP camera, sometimes restarting the device will make the system revert back to a normal state.
To reset, hold the button for at least 5 seconds. The camera will restore factory settings & reboot.
Note: Restoring the factory default setting will lose all the previous settings including the IP address.
You will need to run the IPWizard II program to re-configure the camera to enable it to work properly again.
IN
ST
A
LL
&
C
O
N
N
EC
T