XVision X100 Series, User Manual

Page: 61 / 176

X100 Series Main User Manual 61
IN
ST
A
LL
&
C
O
N
N
EC
T
SE
TU
P
CO
N
FIG
U
RE
RE
CO
RD
IN
G
S
O
FT
W
A
RE
CO
N
FIG
U
RE
White-Light LED
For X100C and X104P Cameras
Use the drop down menu to set the White Light LEDs to turn ON, OFF, AUTO (for turning on
automatically when light level drop) or SCHEDULE.
- If Auto mode is selected, 3 parameters can be set as below
- LED ON Threshold (0~10000): this value sets the threshold to turn ON white-light LED. It should be lower or equal
to the LED OFF Threshold.
- LED OFF Threshold (0~10000): this value set the threshold to turn OFF white-light LED. It should be higher or equal
to LED ON Threshold.
- Delay Time: The delay time between LED ON/OFF switching.
- Note that Current Value is the current luminance from the captured video. Use this as a reference to set the LED
ON/OFF Threshold.
De-Noise
De-Noise can remove or lower unwanted noise and preserve fine details and edges. Use the drop down
menu to select your preferred image quality. Click OK to see the image change in the preview window.
ICR (IR Cut Filter Removable)
For X100V and X100T Cameras
This setting is an optional control function available for the IP cameras that have a Mechanical IR Cut
Filter. Use the toggle bars to adjust the threshold of the setting using the ‘current value’ as a benchmark.
- AUTO: The camera will judge the darkness to switch automatically into Day or Night mode.
- NIGHT/DAY MODE: Set the Day or Night mode manually if required.
- SCHEDULE: Set the schedule for Day or Night mode switching.
- DELAY TIME: In Auto mode, set the delay time between mode shifts to avoid wear and tear of machinery caused by
ICR switching frequently. For example, when using the Night Mode at night, it is possible for the camera to switch
to Day mode if a car light shines into the camera. The delay will allow the camera to monitor the light change
before making the mode change.
Auto Iris
For X100V and X100T Cameras requiring calibration
This option will be available if you are configuring the X100V, and optionally, the X100T (if you
have replaced the standard lens with an Auto Iris lens). The Auto Iris lens on the camera will require
calibration before use.
Click the CALIBRATE button to begin calibration
- A popup window will appear to show the progress of calibration. It may take a few minutes for the camera to
calibrate the lens. Once the lens has calibrated the Auto Iris function of the camera should operate correctly.
Default Settings
Restore to factory image settings.
Note: Failure to calibrate the Auto Iris lens will result in the picture becoming dark over time.