XVision X100 Series, Quick Manual

Page: 8 / 44

8
X100 Series Quick Guide
INSTALL
&
CONNECT
SETUP
CONFIGURE
RECORDING
SOFTWARE
INSTALLATION
The X100C IP Camera can be mounted on a Wall or Ceiling. It can also be desk mounted using the
bracket supplied.
1.
For Wall or Ceiling mounting, make a hole where the camera is to be installed to insert the 12V DC
Power Adaptor and LAN cable.
2.
Feed the 12V DC Power Adaptor, and LAN cables through the hole.
3.
Use the screws and wall plugs supplied to fix the bracket on a wall or ceiling as shown.
4.
Adjust the camera direction and angle of view as required using the bracket.
- Make any lens (focus) adjustments using the manual Focus Ring after you have connected the camera and have
setup live viewing via your PC.
5.
Connect the 12V DC Power Adaptor and LAN cable to camera.
6.
The camera is now ready for you to setup and configure using your PC.
- See SETUP on page 34.
For Wireless Connection
Attach the Wireless Antenna to the camera. Configure your camera’s IP settings using a Wired
connection before you start.
- See SETUP on page 34.
For Audio
Connect the 3.5mm microphone Audio Out Socket to an audio output device such as a speaker with an
amplifier for voice alerting or for enabling the 2 Way Audio function.
Resetting your camera
The Reset Button is used to restore the factory default settings. If you are experiencing problems
with the IP camera, sometimes restarting the device will make the system revert back to a normal state.
To reset, hold the button for at least 5 seconds. The camera will restore factory settings & reboot.
Note: Restoring the factory default setting will lose all the previous settings including the IP address.
You will need to run the IPWizard II program to re-configure the camera to enable it to work properly again.
INSTALL
&
CONNECT
Focus Ring
To Power
To Network
Turn anti-clockwise to
loosen for adjustment