X100 Series Quick Guide
17
INSTALL
&
CONNECT
SETUP
CONFIGURE
RECORDING
SOFTWARE
To Network
Power Cable To Power Adaptor
INSTALLATION
1.
Select a mounting position on a wall or ceiling. Decide whether the cables are to go through the
dome base or via the side cable exit and block off the unused exit with the stopper.
2.
Remove the dome housing by unscrewing the tamper resistant screws with an Allen Key.
3.
Use the mounting base to mark up screw positions and make a hole in the wall or ceiling to insert the
LAN cable and 12V DC Cable (
if using Power over Ethernet, 12V DC Power is not required
).
4.
Feed the cables through the hole.
5.
Use the screws and wall plugs supplied to fix the mounting base.
6.
Insert the cables through the top or side cable exit.
INSTALL
&
CONNECT
Position hole so cables can
be pushed through the top
or side cable exit
To Network
Power Cable To Power Adaptor
Fixing Screws
for fixing base
to ceiling
Tamper Resistant
Screws for fixing
dome cover
CEILING MOUNT
WALL MOUNT
Position hole so cables can
be pushed through the top
or side cable exit
Summary of Contents for X100 Series
Page 1: ...Quick Guide X100 SERIES...
Page 44: ...V1 2 2010 10...