X100 Series Quick Guide
29
INSTALL
&
CONNECT
SETUP
CONFIGURE
RECORDING
SOFTWARE
INSTALLATION
1.
Make a hole in the ceiling where the camera is to be installed.
2.
Use the screws and wall plugs supplied to fix the bracket on the ceiling.
3.
Feed the trailing lead through the Ceiling Mount and fix the camera to the bracket as shown:
4.
Connect the LAN cable and 12V DC Power Adaptor to camera (
if using Power over Ethernet,
12V DC Power Adaptor is not required
).
5.
The camera is now ready for you to setup and configure your camera using your PC.
- See SETUP on page 34.
Screw Dome Housing to
Ceiling Mount using the
Allen Key provided
Hole to feed
trailing lead
through
the ceiling
Hole to feed
trailing lead
through
the wall
Fitting the optional Wall Bracket
1.
Make a hole in the wall where the camera is to be installed and use the screws and wall plugs
supplied to fix the bracket to the surface.
2.
Feed the trailing lead through the Wall Mount and fix the camera to the bracket as shown, then
continue to wire the camera as described above.
Screw Dome Housing to
Ceiling Mount using the
Allen Key provided
INSTALL
&
CONNECT
Summary of Contents for X100 Series
Page 1: ...Quick Guide X100 SERIES...
Page 44: ...V1 2 2010 10...
