X100 Series Quick Guide
27
INSTALL
&
CONNECT
SETUP
CONFIGURE
RECORDING
SOFTWARE
For Audio
Connect the 3.5mm microphone Audio Out Socket to an audio output device such as a speaker with an
amplifier for voice alerting or for enabling the 2 Way Audio function.
Alarm and RS485 Connections
Grouping
Pin
Connect to:
ALARM SENSOR
(Optional)
1
12V DC Power (60mA Max)
2
Alarm Sensor Input
3
GND
4
Alarm Output
RS485
5
RS485 + (
Not used)
6
RS485 - (
Not used)
Resetting your camera
The Reset Button is used to restore the factory default settings. If you are experiencing problems
with the IP camera, sometimes restarting the device will make the system revert back to a normal state.
To reset, hold the button for at least 5 seconds. The camera will restore factory settings & reboot.
Note:
The following Xvision Megapixel lenses are compatible with the X100T IP camera:
•
XL010M-PRO (1.55mm Fixed Iris Megapixel Lens, for 135° viewing angle)
•
XL040M-PRO (4.0mm Fixed Iris Megapixel Lens, for 64° viewing angle)
•
XL0550M-PRO (5.0 to 50.0mm Manual Iris Varifocal Megapixel Lens, for 6 to 49° viewing angle)
•
XL0409A-PRO (4.0 to 9.0mm Auto Iris Varifocal Megapixel Lens, for 30 to 64° viewing angle)*
•
XL4510A-PRO (4.5 to 10.0mm Auto Iris Varifocal Megapixel Lens, for 28 to 57° viewing angle)*
•
XL0550A-PRO (5.0 to 50.0mm Auto Iris Varifocal Megapixel Lens, for 6 to 49° viewing angle)*
•
XL1040A-PRO (10.0 to 40.0mm Auto Iris Varifocal Megapixel Lens, for 8 to 28° viewing angle)*
*Calibration required, see page 41.
Note:
Restoring the factory default setting will lose all the previous settings including the IP address.
You will need to run the IPWizard II program to re-configure the camera to enable it to work properly again.
INSTALL
&
CONNECT
Summary of Contents for X100 Series
Page 1: ...Quick Guide X100 SERIES...
Page 44: ...V1 2 2010 10...
