26
X100 Series Quick Guide
INSTALL
&
CONNECT
SETUP
CONFIGURE
RECORDING
SOFTWARE
5.
Connect the LAN cable and 12V DC Power Adaptor to camera.
6.
The camera is now ready for you to setup and configure your camera using your PC.
- See SETUP on page 34.
Using an Optional Lens
The X100T camera is supplied with a 4.0mm fixed lens for 50° viewing angle. The lens can be manually
replaced with an Xvision Megapixel Varifocal or Fixed Lens to achieve a different viewing angle. Any
lens change should be made after you have connected the camera and have set up live viewing via your
PC so that the focus can be set correctly.
To replace the lens:
1.
Carefully turn the lens to unscrew it from the camera body.
2.
Screw the new lens onto the camera and set the required focus by turning the lens focus ring.
- If you are replacing the lens with a VARIFOCAL lens, the zoom and focus should be adjusted using the separate
zoom and focus rings.
- If you are replacing the lens with a AUTO IRIS lens, ensure the Auto Iris Lens cable is connected to the
corresponding connection on the camera’s side.
3.
When all adjustments have been made, tighten any lens screws to ensure the zoom and focus are set.
4.
If the lens is being replaced by an AUTO IRIS lens it will require calibration before use. Ensure the lens
is calibrated
after
the camera has been set up and configured on the network.
- See Appendix 1: HOW TO CALIBRATE AN AUTO IRIS LENS on page 41.
REPLACING THE LENS
AUTO IRIS LENS CONNECTION
Ensure the Auto Iris cable
is connected here
Note:
Failure to calibrate the Auto Iris lens will result in the picture becoming dark over time.
INSTALL
&
CONNECT
Summary of Contents for X100 Series
Page 1: ...Quick Guide X100 SERIES...
Page 44: ...V1 2 2010 10...
