The camera can store up to 256 panning, tilting and zooming configurations (called
preset positions) which can be recalled at any time.
The manual focusing and IRIS opening settings cannot be stored.
When storing presets, it is important to remember that some are reserved and
cannot be either stored or used for positioning the camera.
Presets from 80 to 99 are reserved for management controls
Presets from 100 to 103, 170 to 173 are reserved for Tracking and Pattern
controls
The following examples show how to program the free Presets and recall them.
Example: programming preset number 32
1)
Position the camera in a certain pan, tilt and zoom configuration.
2)
Enter the command
PRESET
+
32
+
ENTER
.
From this moment onwards, simply enter the command
CALL
+
32
+
ENTER
to
move the camera to the preset position.
The saved value will be written over if the setting is reprogrammed.
The Presets are saved in a permanent memory area of the camera where they
are maintained also when power is disconnected. However, restoring default
settings will delete all preset values.
Press
PRESET
+
83
+
ENTER
to delete all the saved preset values.
The Presets store the coordinates according to an angular reference system.
Therefore, the reference system zero point may become misaligned with the
camera mechanics after prolonged use of the tilting and panning functions.
Minor inaccuracies in preset positions may occur. In this case, calibrate the
angular coordinate system using the
REBOOT SYSTEM
command. This
calibration is automatically run when the camera is switched on.
4.5.
FUNCTION PROGRAM MENU
Use the following control panel command to access the function programming menu.
PRESET
+
95
+
ENTER
At this point, if no password is required for access, the following first level menu will
appear on the screen:
16 / 56