7
Document MT1602P.A
© Xsens Technologies B.V.
MTi-600 series DK User Manual
3
Getting started
3.1 Setting up the Development Kit
Before testing the MTi-600 Development Kit, the MTi-600 needs to be installed onto the MTi-600 DEV.
Place the MTi-600 onto the socket between the spacers. Secure the MTi-600 by screwing the three M2
brass screws in the spacers.
For the MTi-670-DK the GNSS daughter card is already installed on the MTi-600 DEV. To use the GNSS
receiver, the included GNSS antenna needs to be connected to the SMA connector of the GNSS
daughter card.
For using the UART to USB breakout board, refer to section 5.
3.2 Installing MT Software Suite
The MT Software Suite is available from the Xsens website (
www.xsens.com/mt-software-suite
).
The installation procedure consists of a set of several installers and starts with the GUI as shown in
Figure 2.
Figure 2: Start up screen for the MT Software Suite installer
It is possible to choose the components that you need to install (Figure 3).
