32
SYSTem:MODe <LOCal|REMote|RWLock|VOLTage|CURRent|DUAL>
This command sets Control Source to the specified value.
•
LOCal – Local. Control is from the front panel, with limited SCPI command interface capability.
•
REMote – Remote. Control is over the SCPI command interface, with limited front panel capability.
•
RWLock – Remote with Lock. Control is over the SCPI command interface, with no front panel capability.
•
VOLTage – Analog Voltage Control. The voltage setpoint is determined by the Analog Voltage input. SCPI commands
provide the rest of the control, with limited front panel capability.
•
CURRent – Analog Current Control. The current setpoint is determined by the Analog Current input. SCPI commands
provide the rest of the control, with limited front panel capability.
•
DUAL – Analog Dual Control. The voltage setpoint is determined by the Analog Voltage input. The current setpoint is
determined by the Analog Current input. SCPI commands provide the rest of the control, with limited front panel
capability.
SYSTem MODe?
This command returns the presently selected Control Source.
SYSTem:MODe:ASCale <VOLTage|CURRent>,<3|5|10>
This command sets the specified analog channel (voltage or current) to the specified scaling level (3volt, 5 volt, or 10 volt).
SYSTem:MODe:ASCale?
This command returns the presently selected scaling level of the specified analog channel (voltage or current).
SYSTem:ERRor:CLEar
This command clears the Error/Event Queue.
SYSTem:ERRor:CONDition?
This command returns the present Error Conditions state. Contents consist of:
1
Over-Current Error
2
Over-Voltage Error
4
Over-Power Error
8
Output Board Over-Temperature Error
16
Fan Stall Error
32
Output (loss of regulation) Error
64
12V Bias Error
128
3.3V Bias Error
256
Primary (input) Board Temperature Error
512
PFC Failure
1024
Watchdog Error
2048
Self-Test Error
32768
PFC Failure Pending
If multiple bits are set, the result is the sum of the set bit values.
