XP PLS600 Series, Programming Manual

Page: 2 / 33

2
Section Content Page No.
1.6.1 Voltage Setpoint
8
1.6.2 Current Setpoint
1.6.3 Activating/deactivating the output
9
1.6.4 Remote Queries
1.6.5 Additional SCPI Commands
1.6.6 Additional Capabilities
2 REMOTE SENSE CONFIGURATION
10
2.0.1
You can enable or disable the PLS600 Remote Sense capability and set the lead resistance
with the following SCPI commands.
2.0.2
In addition, you can command PLS600 to calculate the lead resistance by executing the
following sequence:
3 CALIBRATION
3.0.1 Calibration Sequence
11
4 SELF-TEST
5 MISCELLANEOUS COMMANDS
5.0.1 *CLS
5.0.2 *IDN?
5.0.3 *RST
5.0.4 SYSTem:PROMpt <ON|OFF>
6 STATUS AND ERRORS
12
6.0.1 Architecture
6.0.2 Questionable Status Fan-Out Registers 14
6.0.3 Operation Status Register 16
6.0.4 Standard Event Status Register 17
6.0.5 Error/Event Queue 18
6.0.6 Error Condition Register 19
6.0.7 Status Byte Register and Service Request Enable Register 20
7 DRIVERS
21
7.1.1 USB drivers
7.1.2 IVI drivers 23
7.1.3 LabVIEW drivers 24
APPENDIX
25
SCPI Commands
List of Figures Page No.
Figure 1 - Overall Status Architecture 12
Figure 2 - Questionable Status Register 13
Figure 3 - Temperature Status Register 14
Figure 4 - Temperature Status Register 15
Figure 5 - Operation Status Register 16
Figure 6 - Standard Event Status Register 17
Figure 7 - Status Byte Register 20