XLT Ovens 1832, Parts & Service Manual

Page: 30 / 94

Technical Support US: 888-443-2751 Technical Support INTL: 316-943-2751
30
OVEN SERVICE PROCEDURES
Large User Interface Programming Procedure
Read the entire instruction before programming.
TIP
To enter factory tech mode press both UP and DOWN button simultaneously for ten (10) seconds
and the following parameters will be displayed: *Displays will auto-exit programming screens af-
ter five (5) seconds of no activity.
1. Software Version
2. Serial Number Entry
3. Elapsed Time:

Total Hours.

Hours Since Filter has been Cleaned.
4. Belt Length: 32 = 1832 36 = 2336 40 = 2440 or 3240 50 = 3250 55 = 3255 or 3855 or 4455
65 = 3265 70 = 3270 or 3870 80 = 3280 or 3880
5. Main Fan Type: Defaults to ON/OFF
6. Split Belt: Defaults to No.
7. Dual Burner: Defaults to No
8. Fuel Type:

Gas or Electric Options.
9. Remote Hood Switch Installed: Defaults to No.
10. Temperature Offset Adjustments:

Offset shown in degrees Fahrenheit.
11. High Temperature range from 590°F (310°C) to Low Temperature.
12. Low Temperature range from 300°F (150°C) to High Temperature.
13. Main Fan (Amps):

Press ENTER to see isolated Amp load.
14. Belt Direction: Defaults to right to left.

Defaults to Right to Left

Can be switched to left to right without physically changing the wire belt direction.
15. Main Fan Off Delay: Defaults to auto 225°F (107°C)
16. Beeper Button Test
17. Done:

Press ENTER to return to operating screen.
ENTER Used to select and save parameters.
UP Increases the setting of the selected param-
eter.
DOWN Decrease the setting of the selected param-
eter.