Xinje VB3, User Manual

Page: 78 / 107

V5 series inverter
72
Fig. Fig. Fig. Fig. 4-23 4-23 4-23 4-23 3-wire 3-wire 3-wire 3-wire operation operation operation operation mode mode mode mode 1 1 1 1
Xi is the multi-function input terminal of X1~X6, here you should define its function as No.9 “3-wire control mode”.
3
3 3
3
：
3-wire
3-wire 3-wire
3-wire control
control control
control mode
mode mode
mode 2
2 2
2
SB1
：
Stop button
SB2
：
Running button
Fig. Fig. Fig. Fig.4 4 4 4-24 -24 -24 -24 3-wire 3-wire 3-wire 3-wire control control control control mode mode mode mode 2 2 2 2
Xi is the multi-function input terminal of X1~X6
，
here you should define its function as No.9 “3-wire control mode”.
Note
Note Note
Note
：
When the inverter stops due to fault, it will start immediately if the terminal control mode and terminal FWD/REV
are enabled and the fault is cleared.
This parameter defines the change rate of reference frequency that is changed by UP/DOWN.
Bi-direction oper-collector output terminal OC
，
the options of this parameter are shown in Table 4-6.
Table
Table Table
Table 4-6
4-6 4-6
4-6 Functions
Functions Functions
Functions of
of of
of output
output output
output terminals
terminals terminals
terminals
P4.09 P4.09 P4.09 P4.09 UP/D UP/D UP/D UP/DOW OW OW OWN N N N speed speed speed speed rate rate rate rate Range Range Range Range
：
0.01 0.01 0.01 0.01
～
99.99H 99.99H 99.99H 99.99Hz/s z/s z/s z/s 1.00 1.00 1.00 1.00 H H H Hz/ z/ z/ z/ssss
P4.10
P4.10 P4.10
P4.10 Bi-direction
Bi-direction Bi-direction
Bi-direction open-collector
open-collector open-collector
open-collector output
output output
output terminal
terminal terminal
terminal OC
OC OC
OC Range
Range Range
Range
：
0
0 0
0
～
20
20 20
20 0
0 0
0
P4.11 P4.11 P4.11 P4.11 Relay Relay Relay Relay output output output output selector selector selector selector Range Range Range Range
：
0 0 0 0
～
20 20 20 20 15 15 15 15
Setting Setting Setting Setting Functions Functions Functions Functions Setting Setting Setting Setting Functions Functions Functions Functions
0 Inverter running (RUN) 11 PLC is finished after one cycle running
1 Frequency arriving signal(FAR) 12 Specified counting value arriving
2 Frequency detection threshold (FDT1) 13
Mid counting value arriving
3 Frequency detection threshold (FDT2) 14 Inverter Ready running finished
（
RDY
）
4 Overload pre-alarm
（
OL
）
15 Inverter fault
5 Inverter under voltage locking
（
LU
）
16 Start frenquence running time
6 External fault stop
（
EXT
）
17 Start DC injection braking time
All manuals and user guides at all-guides.com