Xilinx ZCU102, User Manual

Page: 2 / 137

ZCU102 Evaluation Board User Guide www.xilinx.com 2
UG1182 (v1.2) March 20, 2017
Revision History
The following table shows the revision history for this document.
Date Version Revision
03/20/2017 1.2 Added notes to Dimensions in Chapter 1 . Updated SW6 default switch setting in
Table 2-2 and SD configuration setting in Table 2-4 . Clarified SW6[4:1] boot mode pin
settings under Quad-SPI and SD in Chapter 2 . Changed “DDR SODIMM Memory J1”
heading to “DDR Component Memory” in Table 3-4 . Changed PS_REF_CLK frequency
from 33 MHz to 33.33 MHz in Table 3-12 . Changed “UART2_RTS_O_B” to
“UART2_CTS_O_B” in Table 3-16 . Replaced Figure 3-16 . Changed “QSPI119 (LWR),
U120 (UPR)” heading to “MSP430 U41” in Table 3-17 . Clarified references to
Figure 3-17 in Table 3-19 and Table 3-20 . Added addresses to titles in Table 3-21 and
Table 3-22 and headings in Table 3-23 and Table 3-24 . Changed “22” to “L22” in
Table 3-28 . Updated GTH connectivity for Quad 128, Quad 228, Quad 229, and
Quad 23 under GTH Transceivers in Chapter 3 . Updated bank assignments in
Figure 3-35 . Added callout 44 to Switches in Chapter 3 . Updated Xilinx websites in
Appendix D, Additional Resources and Legal Notices .
11/16/2016 1.1 Updated device part number from XCZU9EG-2FFVB1156 to XCZU9EG-2FFVB1156I
throughout document. Updated board photos ( Figure 2-1 and Figure 2-1 ) to rev 1.0.
Updated Table 2-1 and Table 2-3 . Updated Chapter 3, Component Descriptions .
Updated Appendix B, Master Constraints File Listing .
05/11/2016 1.0 Initial Xilinx release - limited distribution.
Send Feedback