4. Hardware:
Front Panel
1.
Power Status LED
A blue Power Status LED will light to notify you that the Uno device is connected to a power source and switched to
the ‘On’ position.
2.
Network Status LED
•
When the processor has an Ethernet cable / network cable connected the orange Network status LED on the front of
the processor will light - once the processor initializes. If there is no Ethernet / network cable attached it remains off.
Note:
When the Network status LED is on it does not mean that you have established a
Network Connection – only that an Ethernet or network cable is connected to the processor.
Proper Network Connection and Operation is indicated/displayed only in the software’s
“Network View” page (see the Network View & Connection section of this guide).
•
When the processor and software are connected and communicating the orange Network status light will flash.
3.
Input/Output Signal Indicators
Each Input and Output channel has a dual colour LED signal indicator. Green for signal present at -40 dBu and
Red at +17 dBu at the advent of analog clipping.
Rear Panel
(Top - Uno U1616 / Bottom - Uno U1616-N w network audio RJ-45 connectors)
1.
Power On/Off Switch
2.
Fuse Compartment
Should you need to replace the fuse use a T-Series 2.5A-250v fuse. Ensure power to the device is disconnected when
replacing the fuse.
3.
Power Input Connector
Insert the IEC plug connector end of the supplied cable into the rear panel of the Uno. Connect the AC end of the cord
into an AC power source of the correct voltage and frequency (100-240 VAC, 50/60 Hz).
4.
Ethernet Connector
Uno utilizes a TCP protocol for communication with the host PC running the NeuConsole software. The port is a standard
RJ45 (Ethernet) jack.
5.
IP Reset Button.
See the IP Reset / Reset Processor Network Settings section in this guide.
6.
Logic Control Input/Output Port
Utilizing twisted pair wire with an attached terminal block, you can use external signals to control parameters such as
triggering presets within NeuConsole.
7.
Analog Line Outputs
Euro/Phoenix style terminal block output connections utilizing 3.5mm terminal block connectors (included). Use balanced,
shielded audio cabling. Uno has eight (8) or sixteen (16) outputs depending on the model.
8.
Analog Mic/Line Inputs
Euro/Phoenix style terminal block input connections utilizing 3.5mm terminal block connectors (included). Use balanced,
