(8) Double clicking on the
Input
DSP module provides parameter access to the master input Polarity,
Mute, Digital Trim & Meters.
Plus
, via a secondary button located within the opened
Input
module, the processors
Mic/Line Pre-Amp
parameter controls – as shown below.
(9) Click the grey “
Mic/Line Pre-Amp Setup
” button in the opened
Input
module (above left-Pg 15)
to open the processors
Mic/Line Pre-Amp
module (above right-Pg 15) to make parameter
adjusts to the processors
Mic/Line
Pre-Amp
- Mic/Line selection, phantom power and analog
trim.
(10) Note: Level controls can be adjusted in 3 manners.
Course Adjustment:
Click and hold to move the level control itself.
Fine Adjustment:
Fader Style Level Controls - although not indicated in software
version 5.3, you can point and click at the top or
bottom right of any
fader style control to increase or decrease its level in fine adjustments.
Rotary Style Level Controls – point and click the tab on the left and right
side of the rotary control where the pop up “Step Up” or “Step Up”
appears to increase or decrease level in fine adjustment.
Exact Adjustment:
Click to highlight a numeric level and type in the specific
numeric level value.
17. Label DSP Module Source and Destination Connections:
•
During or after completing your parameter adjustments - spend some time labeling the DSP
module I/O Source and Destination connections as well as labeling possibilities in Project
View (. Point & click on any wire to highlight it then type a new label name in the
Component Properties / Link Information
Source and Destination label area at the right of
the work area. As shown in the Matrix mixer at the far right - Source/Destination labels will
populate opened DSP modules – like the matrix mixer- see Hall A / Hall B labels.
