16. NeuConsole Software:
(Project View/Design Mode)
You are able to work with the NeuConsole software without being connected to an Uno
processor (Offline) but for the purpose of this guide example we have established a network
connection to the Uno processor first before beginning to work on a New Design Project.
In the following example the processor is connected and operational.
New Design Project
If you are still in the
Network View
window – Go to
“File”
at the top
left and select
“New Project”
in order to begin a new DSP design
project.
If you have just opened the software - from the
NeuConsole
Startup
window as shown on the left you can select
“New
Design Project”
in order to begin a new DSP design project.
Project View/Design Mode Work Area
Either will open the
Project View / Design Mode
work area page as shown below and as
identified by the white dotted alignment work area.
•
See the
Project
,
Design Mode, and the red
Switch to Online Mode
headings & buttons at
the top left and center of the work area (if not connected to the processor the red Switch to
Online Mode button would not be visible). See the grey
Network View
(Project View) button
at the top
right above Component Properties.
See the
Component Libraries
menu on the
far left and the
Component Properties
menu at the far right of the Project View/Design
Mode work area page as shown below.
