16
CN1100 Access Point - Installation Guide - G7601 - 3.8
This procedure should be completed before installing the CN1100 in a service location.
These steps set up the CN1100 Access Point for use. After completing these configuration steps, the
CN1100 Access Point will be fully functional and ready for operation. It broadcasts on the configured
channel and provides any Internet-ready device the ability to connect wirelessly to the xMax
network, using a secure WiFi connection.
A personal computer is used to configure the CN1100 Access Point. The xMax xAP Management tool
is supported and operates on the following platforms:
Operating Systems
Any version of Windows that supports the listed browsers (XP, Vista, 7, 8, 10)
Any version of Linux that supports Chrome or Firefox
Any version of OSX that supports Chrome or Firefox
Browsers
Firefox 3 or later
Internet Explorer 6 or later
Chrome 13 or later
The examples shown in this document present the view using a computer running Windows 7.
NOTE
This sequence assumes that the CN1100 device is in factory-default configuration and has not been
previously configured.
IMPORTANT: BEFORE YOU CONTINUE
Antennas or dummy loads
MUST
be connected to the two Tx RF ports.
Both Tx RF ports
MUST
be properly terminated
before power (PoE) is applied to the unit.
Applying power without
proper RF port termination might damage the unit
and void the product warranty.
