20
CN1100 Access Point - Installation Guide - G7601 - 3.8
11.
In the
Transmit Power
section, enter the desired transmit power level.
IMPORTANT
The transmit power level
MUST
only be set within allowable FCC limits. Per FCC regulations, only
approved antennas may be used:
The only sector antenna approved for use with the CN1100 is the Ubiquiti AM-913.
The maximum allowable power level is 21 dBm.
The only omni antenna approved for use with the CN1100 is the Laird Technologies OD9-5,
limited to 5 dBi. The maximum allowable power level is 24 dBm.
When using the approved KP Performance KPPA-900MHZ4P90S panel antenna, the maximum
allowable power level is 21 dBm.
The minimum usable level is 5 dBm.
12.
In the
RF Channel
section, set the desired operating channel, and then click
Save
.
For additional information on transmit channel selection, please refer to the topic
CN1100 Management Tool
starting on page 37.
13.
In the
Settings
view, click the
LAN
tab to open the
LAN Configuration
section. The
LAN
Configuration
section displays
10.0.0.3
as the factory-default IP address for the CN1100.
Before changing the IP address, be sure to write down the new IP address
.
After changing the
Hostname
and
IP address
, the new address will then be needed to log in
again to the
CN1100 Management
system.
Hostname:
New IP Address:
NOTES
If
DHCP Mode Stand Alone
is checked, a static range must be configured.
If
DHCP Mode Stand Alone
is NOT checked, refer to the topic
Configure DHCP Settings
in the
xMCC Mobile Control Center Installation and Configuration Guide
for additional
information.
To prevent duplicate IP addresses, the IP address pool for each CN1100
MUST
be unique.
