15
CN1100 Access Point - Installation Guide - G7601 - 3.8
This is a typical tower-mounted CN1100 installation with an
xMax KP Performance
2x4 MIMO Panel
Antenna (KPPA-900MHZ4P90S), exclusively supplied by xG. The required parts are listed.
CN1100 PANEL ANTENNA
INSTALLATION PARTS LIST
SUPPLIED BY xG Technology
1 – CN1100 with Mounting Bracket
1 – PoE++ Power Supply
with Power Cord
1 – Weatherproof Ethernet Kit
8 – Ferrite Beads
1 – GPS Antenna (TNC-type)
and right-angle connector
1 – 2x4 MIMO Panel Antenna
4 – Antenna Cables (N-type)
OBTAIN FROM YOUR PART SUPPLIER
3 – Low-Loss Ethernet Cables
(Lengths as required)
1 – PoE Surge Protector
1 – GPS Antenna Cable (If required)
GPS
ANTENNA
110-240 VAC,
50/60 Hz
PoE++
Power Supply
PoE
Surge
Protector
ETHERNET
DATA
POWER
plus DATA
Install Ferrite Beads as shown.
xMCC
Grounded PoE Surge Protector at Building Entry
Figure 3 —Panel Antenna Configuration
Tx/Rx Tx/Rx
V H
V
Rx
H
Rx
