22
CN1100 Access Point - Installation Guide - G7601 - 3.8
NOTE
xG Technology recommends that the CN1100 Access Point be configured on a bench before installing
the device in the field. Please refer to the topic
Configuring the CN1100 Access Point
on page
16
.
These checklists may be of assistance in assembling the parts needed to complete the installation.
CN1100 Access Point Parts Checklist
SUPPLIED BY xG Technology
OBTAIN FROM YOUR PARTS SUPPLIER
1
CN1100 with Panel Antenna
Mounting Hardware
Antennas
(As required)
1
PoE++ Power Supply
with AC Power Cord
3
UV-resistant CMX outdoor-rated,
Cat 5e UTP Ethernet Cables
(4-6 mm OD; lengths as required)
1
Weatherproof Ethernet Kit
1
Grounded PoE Surge Protector
(CITEL CMJ8-POE-A or equivalent)
6
Ferrite Beads
(Fair-Rite 0443164251)
4
Bulkhead Lightning Arresters
(L-com AL-NMNFB-9 or equivalent)
(If required)
1
xMax Panel Antenna
1
GPS Antenna Cable and Mount
1”–14” thread or ¾” pipe thread
(If required)
1
GPS Antenna
with right-angle Connector
1
Grounding Cable
4
Panel Antenna Cables (N-type)
Network switch or router, if more than
one access point is to be installed
Alternative CN1100 Mounting
Solution (as ordered)
Figure 4 — CN1100 Access Point Parts Checklist
IMPORTANT
The provided weatherproof Ethernet connector requires the use of Ethernet cables with an outside
diameter of 4 to 6 mm.
