Xerox DocuPrint 4050 NPS, Message Manual

Page: 92 / 248

PRINTER CONTROLLER MESSAGES
48-28 XEROX DOCUPRINT 4050/4090/4850/4890/92C NPS MESSAGES GUIDE
F270 Color developer bias
voltage out of range. The color developer bias voltage is out of range.
1. Press the Continue button.
2. If problem persists, contact your service
representative.
F271 Chopped color DC bias
voltage failure. The chopped color DC bias voltage has failed.
1. Press the Continue button.
2. If problem persists, contact your service
representative.
F272 Pretransfer shield voltage
out of range. The pretransfer shield voltage is out of range.
1. Press the Continue button.
2. If problem persists, contact your service
representative.
F273 Pretransfer dicorotron
failure. The pretransfer dicorotron has failed.
1. Press the Continue button.
2. If problem persists, contact your service
representative.
F274 Cleaner bias voltage 1 or
2 fault detected. A cleaner bias voltage 1 or 2 fault has been detected.
1. Press the Continue button.
2. If problem persists, contact your service
representative.
F275 Bead removal device
(BRD) bias voltage fault
detected. A bead removal device (BRD) bias voltage 1 or 2 fault has
been detected.
1. Press the Continue button.
2. If problem persists, contact your service
representative.
F281 Photoreceptor servo
drive fault detected. A photoreceptor servo drive fault has been detected.
1. Press the Continue button.
2. If problem persists, contact your service
representative.
F323 Unable to pass TAC
calibration. The printer is unable to calibrate the TAC.
1. Press the Continue button.
2. If it does not continue immediately you may need to
wait a few minutes then press the Continue button
again.
3. If problem persists, contact your service
representative.
H001 NVM failed power up test-
battery functional test. There is a non-volatile memory (NVM) failure.
1. Press the Continue button.
2. If problem persists, notify your service representative.
Message Explanation/action