Xerox DocuPrint 4050 NPS, Message Manual

Page: 60 / 248

PRINTER CONTROLLER MESSAGES
48-40 XEROX DOCUPRINT 4050/4090/4850/4890/92C NPS MESSAGES GUIDE
P209 PSP requests Sheet
Retry. System communication.
No action required.
If the problem persists, notify your service representative.
P210 ESS Print Command not
received. System communication.
No action required.
If the problem persists, notify your service representative.
P211 ESS retry limit reached. Three consecutive sheet retries were received from the
printer.
No action required.
If the problem persists, notify your service representative.
P212 ROS retry fault. The printer has purged the maximum number of
consecutive sheets (fault P208).
No action required.
If the problem persists, notify your service representative.
P214 Scan system fault. The ROS intensity difference 3, as measured by the scan
detectors, is not balanced.
No action required.
If the problem persists, notify your service representative.
P215 Light leveler output failed. The laser output is too high. The light leveler is not
controlling the laser output.
No action required.
If the problem persists, notify your service representative.
P216 Interpolation connector
fault. The interpolation connector is disconnected or faulty.
No action required.
If the problem persists, notify your service representative.
P218 ESS - IOT data link fault. At least one line of the 8-bit parallel data bus has
malfunctioned.
No action required.
If the problem persists, notify your service representative.
P219 ESS rolled over. The Printer Controller sent a meta reset command to the
printer prior to rolling over.
No action required.
If the problem persists, notify your service representative.
P290 ROS output fault. A ROS output fault has been detected.
No action required.
If problem persists, notify your service representative.
P291 ROS modulator fault. A ROS modulator fault has occurred.
No action required.
If problem persists, notify your service representative.
Message Explanation/action