Xerox DocuPrint 180, Configuration Manual

Page: 87 / 276

XEROX DOCUPRINT NPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM 3-23
3. 3 Starting and stopping the
system
This chapter describes how to start and stop your DocuPrint printing
system. It addresses the proper methods of powering the system on
and off, starting and stopping print jobs, shutting down the system,
and dealing with power failures. It also describes how to switch
between IPS and NPS for dual mode configurations.
Powering on the system
Before you power on the system, ensure the following:
•
The Printer Controller and monitor are connected to dedicated
power receptacles.
•
The printer cable is connected securely to the connector on the
back of the Printer Controller. If the cable is not connected,
make sure the printer and Printer Controller are powered off.
Then connect the cable.
Caution: Do not connect the printer cable to the Printer Controller
when either the Printer Controller or the printer is powered on; you
could destroy the interface card in the Printer Controller.
To power on the Printer Controller:
1. Power on the monitor.
2. Power on the Printer Controller switch located on the back of
the CPU.
The Power On Self Test (POST) runs. The keyboard LEDs flash, and
then the boot process begins.
If the printer power switch is in the on position, the printer controller
will control when the printer is powered on during the boot process.
After the boot process is complete, the DocuPrint user interface (UI)
appears.
Caution: Do not perform any actions at the printer until the boot
process completes and the DocuPrint Print Service window is
displayed.