Xerox DocuPrint 180, Configuration Manual

Page: 168 / 276

INPUT AND OUTPUT PROFILES
6-4 XEROX DOCUPRINT NPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM
Note: To set more than one function for <p6>, add the appropriate
numbers together.
<p7>
Specifies the status signals supported in the form of a sum of
binary values (in parentheses below) specifying which status
signals from the output device are used by the printer; for
example, 5 specifies that the printer should use the ONLINE and
FULL signals (1+4) and ignore the rest.
•
ONLINE (1): output device is connected and available
•
FAULTED (2): output device has an error and printer must stop
delivering sheets to output device immediately (hard stop)
•
FULL (4): printer must stop delivering sheets to output device
as soon as possible (soft stop)
•
SHEET DELIVERED (8): output device has accepted the
printed sheet
•
SET DELIVERED (16): output device has accepted the entire
set
<p8>
Specifies the sheet exit signal type:
0=signal starts on leading edge of sheet
1=signal starts on trailing edge of set
<p9> sheet exit start adjust
Sets the time that the printer waits to send SHEET EXIT and
END OF SET signals to the output device. Acceptable values
range from -100 to +300 ms.
<p10>
Sets the pulse width of the SHEET EXIT signal. Acceptable
values range from 30 to 110 ms.
<p11>
Specifies the end of set offset time. Acceptable values range
from 0 to 255 ms, with a usual value of 10 ms.
<p12>
Specifies dead-cycle time before IOT (printer) shutdown. Allows
time for an operator to unload the finisher without IOT shutdown.
Acceptable values range from 5 to 60 seconds.