3
3-11
Performing WebSetup
Subnet Mask (Token Ring)
—If you need to set the subnet mask, enter one of the fol-
lowing values:
•
255.0.0.0
if the IP address starts with a number less than 128
•
255.255.0.0
if the IP address starts with a number from 128 through 191
•
255.255.255.0
if the IP address starts with a number greater than 191
N
OTE
:
Be sure to confirm the subnet mask setting with your network administrator
before proceeding. In some cases the required setting may be different from those
listed.
Gateway
—If your TCP/IP network has a gateway, and users outside the gateway plan
to print to the DocuColor 40 CP using TCP/IP, enter the gateway address here. By
default, the loopback address, 127.0.0.1, is set. Obtain the correct gateway address
from your network administrator.
The gateway address applies to either a Token Ring or an Ethernet network. If TCP/IP
is running on both an Ethernet and a Token Ring network, the gateway address you
enter must be in the same subnet as either the Ethernet or the Token Ring address.
Protocol Setup (AppleTalk)
Enable AppleTalk
—Select to enable Apple Talk if you have an AppleTalk network con-
nected to the DocuColor 40 CP. This setting enables the DocuColor 40 CP to com-
municate over AppleTalk networks.
Select Zone
—The DocuColor 40 CP searches the network for AppleTalk zones in
your network segment. Scroll through the list to select the AppleTalk zone in which
you want the DocuColor 40 CP to appear. If your segment has only one zone, the
DocuColor 40 CP is assigned to that zone automatically.
If no AppleTalk zone can be found, your network may have no defined zones, or else
the network cable has not been connected (see page 4-4). Choose OK.
Protocol Setup (IPX Frames)
Select Frames
—Click the Select Frames button to specify IPX frames used with Net-
Ware. See your network administrator to verify which frame type to choose.
