Fuser Refresh Mode
Use the Fuser Belt Refresh option to run a fuser belt refresh when the system is
experiencing image quality defects on the printed output. These defects include scratches,
spots, streaks, or bands. The refresh option engages the fuser refresh roll against the
fuser belt and buffs out any scratches that may be occurring on the lead edge or side
edge of the output.
When enabled, the refresh mode occurs every 10,000 prints and takes approximately
60 minutes. This refresh mode occurs while the machine is idle (not printing).
Note
If a job is submitted while the refresh mode is running, the refresh mode stops and the
submitted job prints. The refresh mode does not reconvene after the print job is
completed. Another refresh mode will occur after the next 10,000 prints are reached.
Set the system to run automatic fuser belt refreshes at specific intervals:
• Enabling automatic refresh tells the system to run a fuser belt refresh during a
“Waiting for printer” process.
• Refresh Duration can be set between 1-999 minutes.
• Manual Refresh: This option allows you to set up a manual fuser refresh at the point
of need instead of at a scheduled time. You may have both a scheduled refresh time
programmed and also perform a manual refresh at any time.
The duration default time is 60 minutes. If lead edge or side edge defects still occur
upon completion of a 60-minute refresh mode, the refresh time can be changed to a
longer duration to elminate these defects.
5-25
Xerox
®
Color 800/1000 Press
System Administration Guide
System Settings
