Xerox ApeosPort C6550 I, Network Administrator'S Manual

Page: 105 / 132

Configuration of Scan to FTP/SMB
103
U
s
in
g Sc
an
S
e
rv
ic
e
11
7) Select [Save].
8) Configure [TCP/IP - Subnet Mask] and [TCP/IP - Gateway Address] as the above.
Note • Enter the address in the format “xxx.xxx.xxx.xxx”. The "xxx" should be a numeric value in the
range from 0 to 255. However, 224 or 225.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot be used.
• Specify the subnet mask by a combination of the numbers 0, 128, 192, 224, 240, 248, 252,
254, and 255. However, you cannot use 0 between non-zero values.
• If you do not set the gateway address, enter "0.0.0.0".
5
Select [Close] repeatedly until the [System Settings] screen is displayed.
6
Select [Exit].
7
After the machine is restarted, print out a settings list to confirm that either the SMB
port or FTP client port is enabled and the IP addresses are configured.
For information how to print a setting list, refer to “Print Report/List” in Chapter 12 of the User Guide.
Configuration on the Computer
The following describes the configuration procedure for the computer.
„
Using with FTP
Create a folder for transmission destinations to the server which log in.
„
Using with SMB
Create a folder on the computer and configure it as shared folder.