Xerox 4235, Installation Planning Manual

Page: 43 / 148

XEROX 4235 LPS INSTALLATION PLANNING GUIDE 4-1
4. Printer setup
This chapter explains how to set up your 4235 LPS to print jobs
in XDPM, XPPM, XScript, or HP LaserJet IID emulation modes.
Printer setup options–XDPM
Table 4-1 lists the printer setup options for Xerox Distributed
Print Mode (XDPM). Based on your choices, complete
Checklist 2: Printer setup options–XDPM (figure 4-1). Your
Xerox service representative uses the checklist during
installation.
Table 4-1. XDPM printer setup options
Settings Options
(defaults appear bold) Description
Printer setup XDPM Selects XDPM for 2700/3700/4045 print jobs.
Error sheet
destination
Within job
To other tray Within job–Error sheet and print job arrive at the same output
tray.
To other tray–Error sheet arrives at another output tray.
Status sheet printing On request or error
On request
On error
Disable
On request or error–Status sheets print automatically if errors
occur during a job run and/or if a status sheet request was
made by the user.
On request–Status sheets print only when requested within a
print job.
On error–Prints a status sheet only when errors occur.
Disable–No status sheets print.
Multiple copies Enable
Disable Recognizes or ignores the Print Multiple Copies commands
sent from the host computer system. When this feature is
disabled, the 4235 LPS prints only one set of the job.
Operator text
messages
Enable
Disable
Allows you to send messages from the host that appear on the
4235 screen to notify the operator when a job requires special
attention. When the Operator Text Message is enabled, the
4235 LPS pauses until the operator presses the <CONTINUE>
key.
Offset on job
boundary
Enable
Disable
Defines when and if print jobs are offset in the high capacity
stacker and top output tray. When enabled, print jobs are
offset in the output trays at the beginning of each job.
Offset on error
condition Enable
Disable Allows pages with errors to offset in the output trays. When
enabled, pages with errors are offset in the output tray.
Table 4-1.
XDPM printer setup options (continued)