Xerox 4235, Installation Planning Manual

Page: 104 / 148

HOST COMPUTER SYSTEM GENERATION
7–8 XEROX 4235 LPS INSTALLATION PLANNING GUIDE
/ Is in column 1 and RJPTERM starts in column 16.
name
Is the logical name of the 4235 LPS as specified in the RJPTERM
statement.
VM/RSCS
Environment description
The 4235 LPS may be defined in a BSC environment as a
remote job entry (RJE) terminal operating in any of the three
modes available: 2770, 2780, or 3780. As a remote terminal
the 4235 LPS may be supported by VM and RSCS facilities.
Initialization process review
The 4235 LPS is defined to RSCS in the RSCS CONFIG file.
1.
Specify parameters describing the links to the 4235 LPS
using the LINK statement.
2.
Add the virtual and real UCB address for the 4235 LPS to
the
VM directory for RSCS.
Refer to the IBM manual, RSCSNET Version 2 Planning and
Installation.
System generation procedures
Step 1.
You must define each 4235 LPS with a GENLINK macro
statement in the file AXSLINKS COPY. This statement defines
the name of the 4235 LPS (the "linkid") and the line address (for
leased lines; switched lines are defined separately in step 2).
The statement is:
GENLINK ID=linkid,TYPE=DMTNPT(,LINE=addr)
where:
ID=linkid Specifies the name identifying the 4235 LPS.
TYPE=DMTNPT
Specifies the hardware terminal line manager.
LINE=addr Defines the virtual address of a leased line.
Step 2.
Switched lines are defined in a GENLINE macro statement in
the file LAXLINES COPY.
GENLINE LINE=addr