FEATURES GUIDE
TOUCH SCREEN
The touch screen is what you will use to control your Xenetech Laser Engraver. The screen is controlled by the
touch of your fingertips. If preferred, a stylus or the eraser end of a pencil may be used. Refrain from using sharp
pointed objects on the touch screen as it could easily damage the screen.
Looking at the touch screen you will see a wide variety of menu choices as well as menus. This section will cover
all aspects of the touch screen.
1.
Menu Bar
– There are four menu bars along the top of the touchscreen. Each has their own
specific menu options. To access any menu from the menu bar, simply touch the desired menu
choice.
2.
Last Job Repeat
– As long as the Xenetech Laser is actively connected to VCS, the last job that
was ran on the engraving machine will remain in memory and can be recalled with this button.
3.
Return to Mechanical Home
– This will move the X and Y-axis back to its known mechanical
home location.
Note: This will not mechanical home the system and should not be used as such.
4.
Return to Temp Home
– This will move the X and Y-axis back to its known temp home position,
providing one exists in memory. If there is none, then this button will be grayed out.
5.
VCS Connection Status
– The small computer icon indicates whether you have an active VCS
connection. The blue computer icon indicates that the VCS connection is active. Loss of
connection will be indicated by a red computer with a small red circle with a line drawn through
it.
6.
Micro Jog
– When activated,
the jogging speed will be reduced by ½ and diagonal direction
will be suspended, making it easier to fine-tune a position.
7.
Blower Status
– When the blower is turned off, you will see the
icon. When the blower is
turned on, you will see the
icon.
1
12
5
6
7
8
9
10
11
2
3
4
