4
Mounting to wall, without existing gang box.
1. Using the mounting bracket as a template, mark three hole locations on your
wall. The bracket should be oriented as below. (Fig. 1)
2. Drill at the marked locations: two pilot holes for mounting screws and one lar-
ger hole for the cable.
3. Align mounting bracket to pilot holes. Install the two #6 x 3/4” wood screws,
with plastic wall anchors optional. (Fig. 2)
4. Thread cable from back of
i-touch
™
unit through center of bracket and into
wall hole. (Fig. 3)
5. Slide
i-touch
™
unit onto mounting bracket. Secure at bottom with setscrew.
6. Connect wires per Wiring Instructions (Fig. 4) on the following page.
Mounting to wall, with existing gang box.
1. Remove plastic faceplate from standard single gang box. Keep these screws
in hand.
2. Using screws from step 1, screw mounting plate into gang box.
3. Thread cable from back of
i-touch
™
unit through center of bracket and into
gang box hole.
4. Slide
i-touch
™
unit onto mounting bracket. Secure at bottom with setscrew.
5. Connect wires per Wiring Instructions (Fig. 4) on the following page.
Mounting Instructions
