7
Keeping Track of What’s What and Who’s Who
As fingerprints and codes are entered into your
i-touch™ / Autocloser™
kit
and then sync’d, consider entering this information into a personal log using the
four pages of tables towards the end of this manual. Why might you need this?
1. It helps the Master User know how many total fingerprints and codes have
been entered, to determine how many more can still be added.
2. If the master doesn’t recall whether a specific person has a fingerprint in the
system or not, it will be in the log.
3. If a user (or group of users) forget an assigned code, it will be in the log.
4. If a fingerprint is to be deleted, the master must know the ID of that user. If
that information is in the table then the master doesn’t need to track down
the user and ID that fingerprint in order to remove it from the system. Alter-
natively, the master wouldn’t need to remove all the fingerprints from the
i-
touch™ / Autocloser™
.
5. If a code is to be deleted, the master must know that code. Otherwise, to
remove it the master would need to remove all the codes from the
i-
touch™ / Autocloser™
kit and have only the desired people once again
add their code.
6. It helps keep track of the time remaining with temporary fingerprints and
temporary codes.
Overview Of 1st Time Configuration Steps
1. Physically install your
i-touch™
and
Autocloser™
as earlier described.
2. Make sure
i-touch™
and
Autocloser™
are wired properly and are powered.
3. Create a Master User.
4. Add new fingerprints and codes. Update the tables at the back of this manual.
5. Sync the
i-touch™
and
Autocloser™
.
LED meanings are as follows:
Green LED below the checkmark icon indicates ACCEPT
Yellow LED below the O (center) icon indicates INPUT
Red LED below the X icon indicates ERROR
Instructions
