15
Deleting All Temporary And Permanent Access Codes
(Requires Master User authorization)
1.
Press the
FUNC
key then the
9/DEL ALL CODES
key.
2.
Input MF, or input MC and the
ENTER
key. If the Master User Authoriza-
tion is successful, the
ACCEPT
LED will flash, followed by all LEDs flash-
ing.
3. Press the
ENTER
key to confirm deletion of all access codes. (NOTE:
MC will not be deleted)
4. If all access codes were successfully deleted, the
ACCEPT
LED will flash.
5.
Perform
i- touch™ / Autocloser™
synchronization procedure.
NOTE: Master can remove all codes from the table in the back of this
manual.
Door Access Using Temporary or Permanent Fingerprint
1. Be certain the synchronization procedure has been performed since the
last addition/deletion of fingerprints.
2. Properly place finger on sensor until
INPUT
LED turns off.
3.
If the fingerprint is accepted, then the
ACCEPT
LED will flash. The garage
door will behave as if the existing garage door opener button were
pressed. If no fingerprint match is found, the
ERROR
LED will flash.
Note: Sometimes multiple fingerprint reading attempts are necessary
to maintain tight security.
4.
The
ENTER
key option is now activated and the 10-second timer has
started counting down. (See Tips and Tricks)
Door Access Using Temporary or Permanent Code
1. Be certain the synchronization procedure has been performed since the
last addition/deletion of codes.
2.
Type in an assigned 4-6 digit access code and press the
ENTER
key.
NOTE: The MC cannot be used for entry/exit purposes.
3.
If the access code is accepted, then the
ACCEPT
LED will light. The ga-
rage door will behave as if the existing garage door opener button were
pressed. If no code match is found, the
ERROR
LED will flash.
4.
The
ENTER
key option is now activated and the 10-second timer has
started counting down. (See Tips and Tricks)
Instructions
