12
ID A Fingerprint
1. Press the
FUNC
key followed by the
2/ID PRINT
key.
2. When
INPUT
LED begins flashing, the user should place their finger on th
sensor properly.
3. If the fingerprint is recognized, the
ACCEPT
LED will flash out the ID for that
fingerprint (Valid IDs are 1-30, the Master User’s ID is always the number
1). If the fingerprint was not recognized, the
ERROR
LED will flash
Delete A Temporary Or Permanent Fingerprint
(Requires Master User Authorization)
To delete a user fingerprint the Master User must know the ID assigned to the
user when the fingerprint was entered. (Valid IDs are numbered 1-30, where
the Master User ID is always the number 1). To delete a fingerprint:
1.
Press the
FUNC
key then the
3/DELETE PRINT
key.
2.
Input MF, or input MC and the
ENTER
key.
3.
If the Master User authorization is accepted, the
ACCEPT
LED will flash,
followed by a solid
INPUT
LED.
4.
Enter the ID of the fingerprint to be deleted followed by the
ENTER
key. If
the ID is a single digit (2-9) then a leading zero may be entered but is not
required. (NOTE: MF can not be deleted in this manner.)
5.
If the fingerprint was successfully deleted, the
ACCEPT
LED will flash. If
there is no fingerprint currently associated with that ID, the
ERROR
LED
will flash.
6. If finished with the batch of fingerprint deletions, perform
i-touch™ /
Autocloser™
synchronization procedure.
NOTE: Master may wish to remove deleted fingerprint user’s
information from the User ID / Fingerprint User table at the back of this
manual.
Instructions
