10
Master User Authorization
Any function that requires Master User authorization will require the following
procedure:
* If a MF was chosen, the
INPUT
LED will be flashing. The Master
User should place the finger on the sensor properly and remove it once the
INPUT
LED stops flashing.
* If a MC was chosen, the
INPUT
LED will be solidly lit. Input the MC
followed by the
ENTER
key.
Synchronizing
(Requires Master User authorization)
Synchronizing is required after any addition or deletion of user codes or finger-
prints. This procedure transfers information from the
i-touch™
panel to the
Autocloser™
. Only one sync procedure is necessary for a batch of additions
or deletions.
1.
Put
Autocloser™
device into setup mode by moving
OFF/SETUP/ON
switch to the
SETUP
position.
2.
On the
i-touch
™ press the
FUNC
key and then the
5/SYNC
key.
3.
Input MF, or input MC and the
ENTER
key. If the Master User authoriza-
tion was successful, the
ACCEPT
LED will flash.
4. The
ACCEPT
LED will remain lit until all data has been transmitted. This
may take up to two minutes and there will be a series of beeps. If the
transmission is completed successfully, the
ACCEPT
LED will flash. Oth
erwise, the
ERROR
LED will flash and the procedure must be repeated.
5. Move the
OFF/SETUP/ON
switch back to
ON
.
Add A Permanent Fingerprint
(Requires Master User Authorization)
1.
Press the
FUNC
key followed by the
1/ADD PRINT
key.
2.
Input MF, or MC and the
ENTER
key. If the MF or MC is accepted, the
ACCEPT
LED will flash followed by a flashing
INPUT
LED. If the
AC-
CEPT
LED is not flashing, it either means the Master User wasn’t recog-
nized or that the maximum number of fingerprints have already been
added, and the
ERROR
LED will flash.
3.
Once the MF or MC has been accepted, the new user should place their
finger on the sensor (See Fingerprint Placement Instructions) and remove
Instructions
