Chameleon Controls WKPAD2, Manual, Page: 1 / 12

Manual for WKPAD2 Wireless Keypad
WKPAD2 Wireless Keypad was designed for wireless entry. With the keypad, you can select most
popular rolling code fixed code remote in the world. The password can keep the keypad working with
security. The keypad has 2 different channels available.
How to disassemble the keypad
It is necessary to disassemble the keypad in order to access to the battery and the dip switches. Below
there is a figure of the procedure:
NOTE: TO CONFIGURE THE KEYPAD THE KEYS MUST BE PRESSED WITHIN 1 SECOND (SINCE YOU PRESS
ONE KEY UNTIL YOU PRESS THE FOLLOWING).
1. PASSWORD INPUT AND CHANGE
The default password is the code in the sticker (selected in factory), this password is different for each
keypad, please safekeeping, this code is important.
To check that the password the user remembers is correct , sequentially press “ PIN + CCCC ”, CCCC is the
password, in case the password is wrong, as soon as you press the sequence it will beep 4 times. In case
it is right there will be 4 beeps aswell but there will be a pause before of 4 seconds.
CHANGE PASSWORD
1. Sequentially press “ PIN + CCCC ” ( PIN is a key of the WKPAD2 and CCCC is the current password).
Note: If after this step it beeps 4 times, your current password is incorrect.
2. After, press “ PIN + NNNN” (where NNNN is the new password).
3. Press “ PIN + NNNN” again to confirm the new password, now the passwords has changed to
“ NNNN”.
RESET AS DEFAULT PASSWORD
Remove the battery first. Press the key “ 8” and hold on pressing. Reinstall the battery while pressing the
key, the keypad will beep 1 long beep. The password is reset as default (factory sticker password).
2. REMOTE LEARN
The keypad can work as 2 channels remote with the button “PIN” or “OK”.
1
2
3
Remove the black tap.
à
DIP ACCESS
Unscrew the screws.
Remove the bottom tap.
à
BATTERY ACCESS
1
3
2