Installing the Gateway
975-0330-01-01
2–5
Other Materials and Tools
❐
Additional Ethernet cable (for connecting the Gateway to a router) or
crossover cable (when connecting the Gateway directly to a
computer)
❐
Xanbus power supply (required when connecting the Gateway to a
single GT Inverter)
For a network power supply, contact Xantrex at 1 800 670-0707 or
[email protected].
❐
Weatherproof enclosure (if installing the Gateway outdoors)
❐
Phillips screwdriver
❐
Power drill
❐
Cable clamps or hardware fasteners.
Mounting the Gateway
Indoors
Mount the Gateway on a wall with the connectors facing downwards. For
Gateway dimensions, see Figure A-1 on page A–3.
To mount the Gateway:
1. Hold the unit flush and square against the wall, panel, or horizontal
surface.
If the mounting surface requires pre-drilled holes for the screws, use
the supplied mounting template to mark, then drill, four holes.
2. With a Phillips screwdriver and the supplied #6 screws, secure each
corner of the Gateway to the mounting surface.
Outdoors
Outdoor Gateway installations require the Gateway to be mounted inside
a weatherproof enclosure.
Connecting the Gateway to a Router or Computer
Important:
During setup, a wired connection between the Gateway and the
router is required. During configuration, the Gateway can be switched to wireless
mode and the network cable can be removed. See “Configuring Wireless Mode”
on page 3–13.
www.xantrex.com.ua
Summary of Contents for Gateway
