NetworkHD 100/200/400 Series Installation Guide | Copyright © 2017 WyreStorm Technologies |
wyrestorm.com
9 of 40
Phantom Power
On: Provides 48V DC 100mA to a microphone connected to Mic In
Off: No power supplied – use this setting for dynamic (passive) microphones.
Mic In
3-Pin Phoenix Connector. Connect to a microphone to allow for overlay with selected source audio.
Verify that the Phantom Power switch on the rear panel is set to Off before connecting dynamic
(passive) microphones.
Audio In
3-Pin Phoenix Connector. Connect to the analog audio output of the VGA source connected to the
VGA In. Audio signal received on this port is played ONLY when the VGA input is selected.
Audio Out
3-Pin Phoenix Connector. Connect to the line level input of an audio pre-amplifier or power speaker for
output from selected source.
Contact In
5-Pin Phoenix Connector. Connect to a remote I/O control device such as a panel switch for selecting
inputs remotely.
LED Out
Connects to a remote device to show LED indication of selected source.
RS-232-1
4-Pin Phoenix Connector. Is used for controlling the NHD-SW-0501 via an external control system.
RS-232-2
4-Pin Phoenix Connector. Is used as an RS-232 output to control local devices such as connected
sources.
Reset
Press and hold for a full 5 seconds while the NHD-SW-0501 is powered on to restore factory default
settings.
HDMI In 1-4
19-Pin type A HDMI female digital video/audio input.
VGA In
15-Pin VGA VESA (DSUB 15). Connect to a DSUB 15 VGA output of a device such as a computer.
HDMI Out
19-Pin type A HDMI female digital video/audio output.
Ethernet Port
8-Pin RJ-45 female | 10/100Mbps auto-negotiating. Connect to a supported Layer 2 network switch to
transmit audio/video to a supported NetworkHD decoder.
