NetworkHD 100/200/400 Series Installation Guide | Copyright © 2017 WyreStorm Technologies |
wyrestorm.com
28 of 40
If using NetworkHD 200 series, the following prompt will appear asking for a Layout name. In this example, the 2x2 image could be called
2x2TopLeft.
7.
Enter in a name and click the Ok button. When finished continue to step 11
If using NetworkHD 400 series a different window will appear asking to adjust for display bezel and gaps. It is not always necessary to
adjust for bezel and gaps. However, if parts of the video image are being cut off, display measurements should be made to compensate
appropriately
8.
Start by giving the Layout a name.
9.
Measure the OW (outer width), OH (outer height), VW (viewable width) and VH (viewable height) of a single screen which is part
of the video wall. Measurements should be recorded in centimeters and then multiplied by 100. For example, if the OW (outer
width) of a display is 90cm, 90x100=9000. Once calculated, 9000 would be entered into the OW field. Repeat this process for all
dimensions.
Each section of a video wall allows for the video image to be independently adjusted. To do this select the Advanced Settings tab.
10.
Select a decoder and enter a value in the appropriate field. All values entered will be multiplied by 8
