WTI PollCat NetLink NLJ-VIP, User Manual

Page: 201 / 266

19-1
19 . Command Reference Guide
19.1. Command Mode Access
When the VIP has been properly installed and configured, command mode
can be accessed by a local PC connected directly to the Console Port, by a
remote PC that communicates via modem, or via TCP/IP network.
Notes:
• If the Site I.D. Message (System Parameters Menu, Item 4) has
been defined, the Site I.D. will be displayed before the "PollCat-
NetLink" prompt.
• When the Supervisor Password is entered, the VIP will start up in
Supervisor Mode, allowing access to all menu functions. When
a User password is entered, the VIP will start up in User Mode,
which allows limited access to menu functions.
• The Default Supervisor Mode Password is
SUPER
, and the
default User Mode Password is SMDR .
1.
Remote Access (via Modem):
Start your communications program
and dial the VIP.
a) The unit will respond with the "PollCat-NetLink" (password)
prompt after the carrier is detected.
b) Key in a valid password and press
[Enter]
. Note that the
Password feature is case-sensitive.
c) The Main Menu or the "Ready" prompt will be displayed. If the
"Ready" prompt is displayed, press [Enter] to display the VIP
Main Menu.
2. Local Access (Console Port): Start your communications program.
a) If Set-Up Switch 7 is UP (Enable Console Port Password), the
"PollCat- NetLink" (password) prompt will be displayed.
b) Key in a valid password and press
[Enter]
. Note that the
Password feature is case-sensitive.
c) The Main Menu or the "Ready" prompt will be displayed. If the
"Ready" prompt is displayed, press [Enter] to display the VIP
Main Menu.