S-70
V3307-DI-T-E2B, WSM
ENGINE
(4) Crankshaft
Crankshaft Side Clearance
1. Set a dial indicator with its tip on the end of the crankshaft (1).
2. Measure the side clearance by moving the crankshaft (1) to the
front and rear.
3. If the measurement exceeds the allowable limit, replace the
thrust bearings.
4. If the same size bearing is out of specifications because of the
crankshaft journal wear, replace it with an oversize one referring
to the table and figure.
(Reference)
• Oversize dimensions of crankshaft journal.
W1066738
Crankshaft Alignment
1. Support the crankshaft with V block on the surface plate and set
a dial indicator with its tip on the intermediate journal at right
angle.
2. Rotate the crankshaft on the V block and get the misalignment
(half of the measurement value).
3. If the misalignment exceeds the allowable limit, replace the
crankshaft.
W1067285
Side clearance of
crankshaft
Factory spec.
0.15 to 0.35 mm
0.0059 to 0.013 in.
Allowable limit
0.50 mm
0.020 in.
Oversize
0.20 mm
0.0079 in.
0.40 mm
0.016 in.
Dimension
A
41.10 to 42.10 mm
1.619 to 1.657 in.
41.20 to 42.20 mm
1.622 to 1.661 in.
Dimension
B
28.20 to 28.25 mm
1.111 to 1.112 in.
28.40 to 28.45 mm
1.119 to 1.120 in.
Dimension
C
2.8 to 3.2 mm radius
0.11 to 0.12 in. radius
2.8 to 3.2 mm radius
0.11 to 0.12 in. radius
(0.8S)
The crankshaft journal must be fine-finished to higher than
∇∇∇∇.
(1) Crankshaft
(A) Side Clearance of Crankshaft
Crankshaft alignment
Allowable limit
0.02 mm
0.0008 in.
KiSC issued 01, 2009 A
