S-58
V3307-DI-T-E2B, WSM
ENGINE
Reassembling the Brush
1. Fit the brush with its sliding face in the clockwise direction when
viewed from front.
IMPORTANT
Q
• Be sure to keep the 2 brushes deep in the brush holder.
Otherwise the rotor and the rear section can not be fitted
into the position.
• Use a 4.0 mm (0.16 in.) hex. wrench to push the brushes into
place.
• Using a pin-pointed (2.0 mm (0.079 in.)) punch, keep the
brushes from popping out.
2. Match the tally line of the front section with that of the rear
section.
3. Tighten the 4 screws, and draw out the pin-pointed punch out of
the brush holder.
W1075117
Bearing at Slip Ring Side
1. Lightly secure the rotor (1) with a vise to prevent damage, and
remove the bearing (2) with a puller (3).
W1019701
(1) Marking
(1) Rotor
(2) Bearing
(3) Puller
KiSC issued 01, 2009 A