S-33
V3307-DI-T-E2B, WSM
ENGINE
Injection Nozzle Oil Seal (If necessary)
1. Remove the injection nozzle oil seal (2) from cylinder head cover
(1).
(When reassembling)
• When installing the injection nozzle oil seal (2), use new one.
W1054100
Cylinder Head
1. Remove the cylinder head screw in the order of (10) to (1), and
remove the cylinder head.
2. Remove the cylinder head gasket.
(When reassembling)
• Replace the head gasket with a new one.
• When mounting the gasket, set it to the knock pin hole. Take
care not to mount it reversely.
• The cylinder head should be free of scratches and dust.
• Take care for handling the gasket not to damage it.
• Install the cylinder head.
• Tighten the cylinder head screw gradually in the order of (1) to
(10) after applying engine oil.
• Be sure to adjust the valve clearance. See the “Valve
Clearance”.
• It is not necessary to retighten the cylinder head screw after
running the engine for 30 minutes.
IMPORTANT
Q
• When replacing a piston, piston pin bush, connecting rod or
crankpin bearing, select the cylinder head gasket thickness
to meet with the top clearance refer to the “Selecting
Cylinder Head Gasket”.
W1170923
(1) Cylinder Head Cover
(2) Injection Nozzle Oil Seal
Tightening torque
Cylinder head
mounting screw
187 to 196 N·m
19.0 to 20.0 kgf·m
138 to 144 lbf·ft
(10) to (1) : To Loosen
(1) to (10) : To Tighten
A : Front Cover Side
B : Flywheel Housing Side
KiSC issued 01, 2009 A
