111
Advanced Operation
Advanced Operation
Changing the DCS code remotely
The KG-1000G Plus will allow the RX DCS code of both areas to be changed remote-
ly. The code change is only temporary. After the radio is rebooted the code will return to
the original setting.
To change the RX DCS code remotely, first refer to the Activating the Remote Control
sub-section (page 106) to activate remote control mode.
With remote control mode successfully activated, hold the controlling radio’s PTT,
press 0 + 6 + (four digit DCS code) and then release the PTT. The first digit should be
0 for a positive code and 1 for a negative code. For example, to change to code D023N,
enter: 0 6 0023. To change to code D023I, enter: 0 6 1023.
A beep should be heard on the controlling radio confirming that the command was
received. If no beep was heard, the command failed.
After changing the setting, you will need to exit remote control mode on the controlled
radio. Hold the controlling radio’s PTT, press 9+9 and then release the PTT. The
controlling radio will beep and show the DTMF ID of the controlled radio, confirming
