107
Advanced Operation
Advanced Operation
Note: If the controlled radio does not receive a DTMF tone from the controller within
30 seconds, the connection will be automatically exited. The controlling radio can also
exit the connection by transmitting 9+9.
Changing the frequency remotely
The KG-1000G Plus will allow the frequency of the non-active area to be changed re-
motely, provided the new frequency is not in the same band as the active area frequency.
For example, if the active area frequency is UHF, the new frequency sent remotely must
be VHF.
To change frequencies remotely, first refer to the Activating the Remote Control
sub-section (page 106) to activate remote control mode.
With remote control mode successfully activated, hold the controlling radio’s PTT,
press 0 + 1 + Frequency (total of 8 digits) and then release the PTT. For example, to
change to frequency 162.450, enter: 0 1 16245000.
A beep should be heard on the controlling radio confirming that the command was
received. The controlled radio will reboot and adjust the frequency to match the com-
