Woodward 2301E-ST, Installation And Operation Manual

Page: 71 / 126

Manual 26694 2301E-ST
Woodward 69
07 DISCRETE INPUT G indicates status of discrete input G.
08 DISCRETE INPUT H indicates status of discrete input H.
09 DISCRETE OUTPUT #1 indicates status of discrete output #1.
10 DISCRETE OUTPUT #2 indicates status of discrete output #2.
11 DISCRETE OUTPUT #3 indicates status of discrete output #3.
12 DISCRETE OUTPUT #4 indicates status of discrete output #4.
13 INTERNAL L/S RELAY K1 indicates status of discrete output driving the internal load-sharing relay.
S** HARDWARE OUTPUT TEST **
Figure 3-30. Service: S** HARDWARE OUTPUT TEST ** Menu
This section allows the operator to test the analog output and the relay driver outputs by artificially forcing
the signals. This test can only be performed in the shutdown state.
01 ENABLE HARDWARE TEST dflt=FALSE (FALSE, TRUE)
Set to TRUE to test the hardware output. When test is finished, it should set to FALSE.
02 HARDWARE TEST MODE displays the status of the HARDWARE TEST mode.
03 AO FORCE VALUE (4–20 MA) dflt=4 (4, 20)
Set this value to the desired value, to test the analog output on terminals 16, 17.
04 ANALOG OUT (mA) displays the actual current output in milliamps.
05 ANOUT, 4 MA OFFSET dflt=0.0 (-100.0,100.0)
Adjusts the analog output current to a specified offset.
06 ANOUT, 20 MA GAIN
dflt=1.0 (0.0,10.0)
Adjusts the analog output current to a specified gain or level.
07 TURN ON DO-1 dflt=FALSE (FALSE, TRUE)
Set to TRUE to turn ON the relay driver output #1. If test is finished, it should set to FALSE.
08 DISCRETE OUTPUT #1 displays the state of discrete output #1.
09 TURN ON DO-2 dflt=FALSE (FALSE, TRUE)
Set to TRUE to turn ON the relay driver output #2. If test is finished, it should set to FALSE.
Released