Woodward 2301E-ST, Installation And Operation Manual

Page: 10 / 126

Manual 26694 2301E-ST
Woodward 8
Nippon Kaiji Kyokai: Requirements specified in Chapter 1, Part 7 of Guidance for the approval
and Type Approval of materials and equipment for Marine use and
relevant Society’s Rules.
RINA Rules for the Classification of Ships – Part C_Machinery, Systems and
Fire Protection. Ch. 3, Sect. 6, Table 1.
Other International Compliance
Australia &
New Zealand:
Compliance is limited to application for those units bearing the Regulatory
Compliance Mark (RCM) or used in applications where only EMC is
applicable, such as “Fixed Installations” where the RCM & a DoC are not
required.
EMC: The Electromagnetic Compatibility (EMC) portion of RCM Declaration for
the Australian Radio Communications Act (with applicable amendments)
is a separate document only created for marked products. The products
with RCM on the label have a DoC available, but all products comply with
CISPR11 Group 1 Class A emissions per EN/IEC 61000-6-4 via
Electromagnetic Interference (EMI) testing. This product is part of “Fixed
Installations”.
Special Conditions for Safe Use:
The control must be installed in a suitable enclosure. The final combination must be approved by the local
authority having jurisdiction.

Connect the ground terminal to earth ground.

Use supply wire rated for minimum 75 °C

Use signal wire rated for a minimum of 240 Vac.

Per EN 60079-15:2010: Device meets ATEX Zone 2 requirements when installed in an ATEX
compliant IP54 or better enclosure.

T3 when the Potential Transformer input is 240 Vac

T4 when the Potential Transformer input is 120 Vac
EXPLOSION HAZARD—Do not remove covers or connect/disconnect
electrical connectors unless power has been switched off or the area
is known to be non-hazardous.
Substitution of components may impair suitability for Class I,
Division 2.
RISQUE D’EXPLOSION—Ne pas enlever les couvercles, ni
raccorder / débrancher les prises électriques, sans vous en
assurez auparavant que le système a bien été mis hors tension;
ou que vous vous situez bien dans une zone non explosive.
La substitution de composants peut rendre ce matériel
inacceptable pour les emplacements de Classe I, Division 2.
Released