-46-
Model W1763W (For Machines Mfd. Since 09/16)
SE
RV
IC
E
The fence can be resurfaced or made flat with a jointer
to correct any warping. This procedure should only be
done if the fences will not align with each other after
careful adjustment or they are warped.
To.resurface.fence,.do.these.steps:
1.
Make sure fence face-mounting screws are far
enough below surface of fence that they will not
contact jointer knives during operation.
Note:
New fence faces can easily be made out
of hardwood and resurfaced by using this same
procedure.
2.
Align both fence faces as straight as possible using
a straightedge or your jointer table as an alignment
guide.
3.
Resurface fences on jointer, as shown in
Figure.63
.
Resurfacing.Fence
Figure.63.
Example photo of resurfacing a
shaper fence on a jointer.